I finally finished up the last few pieces of the Ice Resin jewelry I was working on. On both of these pieces I hand made the bales as the resin is thicker than what a jump ring will go through and I didn't want to glue a bale to the back. I use a drill press to easily make the holes. It can be a bit tricky to get the hole started as curves on the pieces make the drill bit slip. I've found that if I use a awl to make a slight indentation into the resin, I can keep my bit in the right place.
Once again, you can purchase these pieces over on my sales blog:
No comments:
Post a Comment